臥式離心機運轉時出現的問題 （Problems with horizontal centrifuge operation）

為了保證臥式離心機的正常運轉，必須掌握離心機運轉中的一些小問題，這有助于提高生產能力，增加經濟效益。操作中最普遍的問題是噪音。 In order to ensure the normal operation of horizontal centrifuges, it is necessary to master some minor problems in centrifuge operation, which is conducive to improving production capacity and increasing economic benefits. The most common problem in operation is noise. ? ? ? 調試檢驗空離心機正常操作中，油的溫度調節，油溫保持在約40-60度，調節泵的流速，從而使材料達到推的最大數量均勻地加入到懸浮液中，觀察機器的分離條件，對于懸浮液的溫度，濃度，進料和其它因素進行調整（在水平兩階段推料離心機作為一個例子HR500-N）來挑選最佳工作參數：當盤之間的間隙和濾布層推動器過大，濾餅層的鼓表層太薄，濾餅層的厚度將是由于跨越滾筒不均勻，造成機器的振動，應增加進料速率或增加進料濃度，但過度的進料部分脫水的懸浮液就來不及洗去殘基出現“泄漏”會造成機器的振動。 Debugging check air centrifuge in normal operation, the oil temperature control, oil temperature kept at about 40 to 60 degrees, adjust the flow rate of the pump, so that the material to push the maximum number of evenly into the suspension, to observe the separation conditions of machines, for suspending liquid temperature, concentration, feed and other factors to adjust (at the level of two-stage pushing centrifuge as an example HR500 N) to select the optimal working parameters: When the gap between the plate and the driver is too large, filter cloth layer of the surface of the drum filter cake layer is too thin, the thickness of the filter cake layer will be due to the uneven cross roller, lead to the vibration of the machine, should increase the feed rate or increase the feed concentration, but excessive feed part of dehydration suspension often wash residues appear "leaked" will cause the vibration of the machine. ? ? ? 臥式離心機對于含細微不同粒子、難過濾的懸浮液，可適當進行下降推料次數，濾渣在機內沒有停留一段時間不斷加長，下降濾渣含濕量，反之公司對于含粗晶粒、易過濾的懸浮液，在保證濾渣含濕量的前提工作條件下，則可以通過提高推料次數，減少濾渣在機內的停留一定時間以獲得一個更高的產量。 Horizontal centrifuge for suspending liquid containing slightly different particle, difficult to filter, can be appropriately to reduce the number of pushing, filter residue within the machine did not stop for a period of time lengthened, reduce the filter cake moisture content, and enterprise for suspending liquid containing coarse grain size, easy to filter, in the prerequisite of the moisture content residue in working condition, can push by improving the material number, reduce residue stay in the machine for a certain time to obtain a higher yield. ? 所述機器通過更換主滑輪，可以得到各種速度運行之后，用戶可以確定根據需要更換滑輪該方法的最佳操作參數，工作應該是在此狀態下是穩定的。 After the machine can run at various speeds by replacing the main pulley, the user can determine the optimal operating parameters of the method of replacing the pulley according to the need, and the work should be stable in this state.